Study › General › G1C › G1C06

G1C06

COMMISSION'S RULES · - Transmitter power regulations; data emission standards; 60-meter operation requirements

G1C06§ 97.313G1C →

What is the limit for transmitter power on the 1.8 MHz band?

  1. A200 watts PEP output
  2. B1000 watts PEP output
  3. C1200 watts PEP output
  4. D1500 watts PEP output
Why Section 97.313 sets a general maximum of 1500 watts PEP output for amateur stations, and the 1.8 MHz (160 meter) band gets that full limit with no special reduction. The only bands with lower caps are 30 meters (200 watts PEP), the 60 meter channels (100 watts PEP effective radiated power relative to a dipole), and certain segments restricted for Novice/Technician operators. As always, 97.313(a) still requires using the minimum power necessary to carry out the communication.
Watch out The 200 watt figure belongs to the 30 meter band (10.1 MHz), not 160 meters; older rules once limited 1.8 MHz power, but that restriction no longer exists.
1500 W PEP is the default everywhere; the exceptions to memorize are 200 W on 30 m and 100 W ERP on 60 m.
HamSandwich explanation, first draft. The question and answers are the NCVEC text.
47 CFR 97.313 Transmitter power standards.

(a) An amateur station must use the minimum transmitter power necessary to carry out the desired communications.

(b) No station may transmit with a transmitter power exceeding 1.5 kW PEP.

(c) No station may transmit with a transmitter power output exceeding 200 W PEP:

(1) On the 10.10-10.15 MHz segment;

(2) On the 3.525-3.60 MHz, 7.025-7.125 MHz, 21.025-21.20 MHz, and 28.0-28.5 MHz segment when the control operator is a Novice Class operator or a Technician Class operator; or

(3) The 7.050-7.075 MHz segment when the station is within ITU Regions 1 or 3.

(d) No station may transmit with a transmitter power exceeding 25 W PEP on the VHF 1.25 m band when the control operator is a Novice operator.

(e) No station may transmit with a transmitter power exceeding 5 W PEP on the UHF 23 cm band when the control operator is a Novice operator.

(f) An Earth station or telecommand station may transmit on the 435-438 MHz segment with a maximum of 611 W effective radiated power (1 kW equivalent isotropically radiated power). The transmitting antenna elevation angle between the lower half-power (−3 dB relative to the peak or antenna bore sight) point and the horizon must always be greater than 10°. No other station may transmit with a transmitter power exceeding 50 W PEP on the UHF 70 cm band from an area specified in § 2.106(c)(270)(i) of this chapter, unless expressly authorized by the FCC after mutual agreement, on a case-by-case basis, between the Regional Director of the applicable field facility and the military area frequency coordinator at the applicable military base.

(g) No station may transmit with a transmitter power exceeding 50 W PEP on the 33 cm band from within 241 km of the boundaries of the White Sands Missile Range. Its boundaries are those portions of Texas and New Mexico bounded on the south by latitude 31°41′ North, on the east by longitude 104°11′ West, on the north by latitude 34°30′ North, and on the west by longitude 107°30′ West.

(h) No station may transmit with a transmitter power exceeding 50 W PEP on the 219-220 MHz segment of the 1.25 m band.

(i) 60 m band power requirements: No station may transmit on the frequencies 5.332, 5.348, 5.373, and 5.405 MHz in the 60 m band with a radiated power exceeding 100 W ERP. No station may transmit in the 5.3515-5.3665 MHz band with a radiated power exceeding 9.15 W ERP. For the purpose of computing ERP, the transmitter PEP will be multiplied by the antenna gain relative to a half-wave dipole antenna. A half-wave dipole antenna will be presumed to have a gain of 1 (0 dBd). Licensees using other antennas must maintain in their station records either the antenna manufacturer's data on the antenna gain or calculations of the antenna gain.

(j) No station may transmit with a transmitter output exceeding 10 W PEP when the station is transmitting a SS emission type.

(k) No station may transmit in the 135.7-137.8 kHz (2200 m) band with a transmitter power exceeding 1.5 kW PEP or a radiated power exceeding 1 W EIRP.

(l) No station may transmit in the 472-479 kHz (630 m) band with a transmitter power exceeding 500 W PEP or a radiated power exceeding 5 W EIRP, except that in Alaska, stations located within 800 kilometers of the Russian Federation may not transmit with a radiated power exceeding 1 W EIRP.

(m) No station may transmit with a peak equivalent isotropically radiated power (EIRP) exceeding 316 W in the 76-81 GHz (4 mm) band.

eCFR text as of 1 Sep 2026 · read on ecfr.gov
← G1C05 All of G1C G1C07 →

The rest of G1C

  1. G1C01 What is the maximum transmitter power an amateur station may use on 10.140 MHz?
  2. G1C02 What is the maximum transmitter power an amateur station may use on the 12-meter band?
  3. G1C03 What is the maximum bandwidth permitted by FCC rules for amateur radio stations transmitting on USB frequenci…
  4. G1C04 Which of the following is required by the FCC rules when operating in the 60-meter band?
  5. G1C05 What is the limit for transmitter power on the 28 MHz band for a General Class control operator?
  6. G1C06 What is the limit for transmitter power on the 1.8 MHz band?
  7. G1C07 What must be done before using a new digital protocol on the air?
  8. G1C11 What measurement is specified by FCC rules that regulate maximum power?
Yaesu FT-991A HF/VHF/UHF All Mode TransceiverSponsored · View on Amazon →Yaesu FT-65R VHF/UHF Dual Band HandheldSponsored · View on Amazon →