Study › General › G7C › G7C06

G7C06

PRACTICAL CIRCUITS · - Transceiver design; filters; oscillators; digital signal processing (DSP)

G7C06G7C →

Which of the following is an advantage of a digital signal processing (DSP) filter compared to an analog filter?

  1. AA wide range of filter bandwidths and shapes can be created
  2. BFewer digital components are required
  3. CMixing products are greatly reduced
  4. DThe DSP filter is much more effective at VHF frequencies
Why A DSP filter is defined by software coefficients rather than by physical inductors, capacitors or crystals, so the same hardware can produce almost any bandwidth, center frequency and response shape just by loading different numbers. That lets a radio offer continuously variable passband width, steep brick-wall skirts, notch filters and noise reduction from one converter and processor. An analog filter's response is fixed by the parts soldered in, so each bandwidth needs its own filter.
Watch out The claim about reducing mixing products confuses filtering with mixer design; mixing products come from the nonlinear mixing stage, and DSP filtering usually happens after conversion to a low IF or baseband, not at VHF as the frequency choice suggests.
DSP filters are made of math, not parts: change the numbers, change the bandwidth and shape.
HamSandwich explanation, first draft. The question and answers are the NCVEC text.
← G7C05 All of G7C G7C07 →

The rest of G7C

  1. G7C01 What circuit is used to select one of the sidebands from a balanced modulator?
  2. G7C02 What output is produced by a balanced modulator?
  3. G7C03 What is one reason to use an impedance matching transformer at a transmitter output?
  4. G7C04 How is a product detector used?
  5. G7C05 Which of the following is characteristic of a direct digital synthesizer (DDS)?
  6. G7C06 Which of the following is an advantage of a digital signal processing (DSP) filter compared to an analog filt…
  7. G7C07 What term specifies a filter's attenuation inside its passband?
  8. G7C08 Which parameter affects receiver sensitivity?
  9. G7C09 What is the phase difference between the I and Q RF signals that software-defined radio (SDR) equipment uses …
  10. G7C10 What is an advantage of using I-Q modulation with software-defined radios (SDRs)?
  11. G7C11 Which of these functions is performed by software in a software-defined radio (SDR)?
  12. G7C12 What is the frequency above which a low-pass filter's output power is less than half the input power?
  13. G7C13 What term specifies a filter's maximum ability to reject signals outside its passband?
  14. G7C14 The bandwidth of a band-pass filter is measured between what two frequencies?
Tram 1481 Dual Band Base AntennaSponsored · View on Amazon →ARRL Ham Radio License ManualSponsored · View on Amazon →